AWK-1137C-JP
AWK-1137C SeriesEntry-level industrial Wi-Fi 4 (802.11n) wireless clients
- IEEE 802.11n Wi-Fi 4 client
- Selectable dual-band Wi-Fi with data rates up to 300 Mbps
- AP-agnostic millisecond-level Client-based Turbo Roaming
- Compact size for easy installation
- Easy network setup with Network Address Translation (NAT)
- Integrated antenna isolation to protect against external electrical interference
- Comprehensive interfaces with one serial port and two Ethernet LAN ports
Certifications E1 · UL Listed · CE · FCC
Ships from and sold by A5 IT, an authorized Moxa reseller.
Specifications
WLAN Interface
- WLAN Standards
- 2.4 GHz: 802.11n with 64 QAM support, 20/40 MHz 5 GHz: 802.11n with 64 QAM support,20/40 MHz WMM for QoS
- Frequency Band for JP (20 MHz operating channels)
- 2.412 to 2.484 GHz (14 channels) 5.180 to 5.240 GHz (4 channels) 5.260 to 5.320 GHz (4 channels) DFS (Dynamic Frequency Selection) channel support: In AP mode, when a radar signal is detected, the device will automatically switch to another channel. However according to regulations, after switching channels, a 60-second availability check period is required before starting the service. 5.500 to 5.700 GHz (11 channels) DFS (Dynamic Frequency Selection) channel support: In AP mode, when a radar signal is detected, the device will automatically switch to another channel. However according to regulations, after switching channels, a 60-second availability check period is required before starting the service.
- Wireless Security
- WEP encryption (64-bit and 128-bit) WPA/WPA2-Enterprise (IEEE 802.1X/RADIUS, TKIP, AES) WPA/WPA2-Personal
- Wireless Roaming
- Turbo Roaming The Turbo Roaming recovery time indicated herein is an average of test results documented, in optimized conditions, across APs configured with interference-free 20-MHz RF channels, WPA2-PSK security, and default Turbo Roaming parameters. The clients are configured with 3-channel roaming at 100 Kbps traffic load. Other conditions may also impact roaming performance. For more information about Turbo Roaming parameter settings, refer to the product manual.
- Transmission Rate
- 2.4 GHz: Up to 144.4 Mbps 5 GHz: Up to 300 Mbps
- Transmitter Power
- Read more US EU JP 2.4 GHz 26 dBm 18 dBm 18 dBm 5 GHz (UNII-1) 23 dBm 23 dBm 23 dBm 5 GHz (UNII-2) 23 dBm 23 dBm 23 dBm 5 GHz (UNII-2e) 23 dBm 23 dBm 23 dBm 5 GHz (UNII-3) 23 dBm – – Note: Based on regional regulations, the maximum transmission power allowed on the UNII bands is restricted in the firmware, as indicated above.
- Transmitter Power for 802.11a (Dual Chain)
- 23±1.5 dBm @ 6 to 24 Mbps 21±1.5 dBm @ 36 Mbps 29±1.5 dBm @ 48 Mbps 18±1.5 dBm @ 54 Mbps
- Transmitter Power for 802.11n (5 GHz, Dual Chain)
- 23±1.5 dBm @ MCS0/8 20 MHz 18±1.5 dBm @ MCS7/15 20 MHz 23±1.5 dBm @ MCS0/8 40 MHz 18±1.5 dBm @ MCS7/15 40 MHz
- Transmitter Power for 802.11b (Dual Chain)
- 26±.1.5 dBm @ 1 Mbps 26±1.5 dBm @ 2 Mbps 26±1.5 dBm @ 5.5 Mbps 25±1.5 dBm @ 11 Mbps
- Transmitter Power for 802.11g (Dual Chain)
- 22±1.5 dBm @ 36 Mbps 19±1.5 dBm @ 54 Mbps 23±1.5 dBm @ 6 to 24 Mbps 20±1.5 dBm @ 48 Mbps
- Transmitter Power for 802.11n (2.4 GHz, Dual Chain)
- 23±1.5 dBm @ MCS0/8 20 MHz 17±1.5 dBm @ MCS7/15 20 MHz 23±1.5 dBm @ MCS0/8 40 MHz 17±1.5 dBm @ MCS7/15 40 MHz
- Receiver Sensitivity for 802.11a (measured at 5.680 GHz)
- Typ. -90 @ 6 Mbps Typ. -88 @ 9 Mbps Typ. -87 @ 12 Mbps Typ. -85 @ 18 Mbps Typ. -81 @ 24 Mbps Typ. -78 @ 36 Mbps Typ. -74 @ 48 Mbps Typ. -73 @ 54 Mbps Note: Due to a limitation in the receiver sensitivity performance for channels 153 and 161, it is recommended to avoid using these channels in your critical applications.
- Receiver Sensitivity for 802.11n (5 GHz)
- Typ. -69 dBm @ MCS7 20 MHz Typ. -70 dBm @ MCS15 20 MHz Typ. -64 dBm @ MCS7 40 MHz Typ. -66 dBm @ MCS15 40 MHz Note: Due to a limitation in the receiver sensitivity performance for channels 153 and 161, it is recommended to avoid using these channels in your critical applications.
- Receiver Sensitivity for 802.11b (measured at 2.437 GHz)
- Typ. -89 dBm @ 1 Mbps Typ. -89 dBm @ 2 Mbps Typ. -89 dBm @ 5.5 Mbps Typ. -88 dBm @ 11 Mbps
- Receiver Sensitivity for 802.11g (measured at 2.437 GHz)
- Typ. -88 dBm @ 6 Mbps Typ. -88 dBm @ 9 Mbps Typ. -88 dBm @ 12 Mbps Typ. -87 dBm @ 18 Mbps Typ. -84 dBm @ 24 Mbps Typ. -81 dBm @ 36 Mbps Typ. -77 dBm @ 48 Mbps Typ. -75 dBm @ 54 Mbps
- Receiver Sensitivity for 802.11n (2.4 GHz; measured at 2.437 GHz)
- Typ. -70 dBm @ MCS7 20 MHz Typ. -70 dBm @ MCS15 20 MHz Typ. -64 dBm @ MCS7 40 MHz Typ. -65 dBm @ MCS15 40 MHz
- WLAN Operation Mode
- Client Client-Router Slave Sniffer
- Antenna
- External, 2/2 dBi Omni-directional
- Antenna Connectors
- 2 RP-SMA female
Ethernet Interface
- 10/100BaseT(X) Ports (RJ45 connector)
- 2
- Standards
- IEEE 802.3 for 10BaseT IEEE 802.3u for 100BaseT(X) IEEE 802.1Q for VLAN Tagging
Ethernet Software Features
- Management
- DHCP Server/Client HTTP IPv4 LLDP SMTP SNMPv1/v2c/v3 Syslog TCP/IP Telnet UDP Proxy ARP VLAN Wireless Search Utility MXconfig MXview One MXview Wireless Turbo Roaming Analyzer
- Routing
- Port forwarding Static Route NAT
- Security
- HTTPS/SSL RADIUS SSH
- Time Management
- NTP Client SNTP Client
Firewall
- Filter
- ICMP MAC address IP protocol Port-based
Serial Interface
- Connector
- DB9 male
- Serial Standards
- RS-232, RS-422/485, RS-232/422/485
- Operation Modes
- Disabled, Real COM, RFC2217, TCP Client, TCP Server, UDP
- Data Bits
- 5, 6, 7, 8
- Stop Bits
- 1, 1.5, 2
- Parity
- None, Even, Odd, Space, Mark
- Flow Control
- None, RTS/CTS, XON/XOFF
- Baudrate
- 75 bps to 921.6 kbps
- Serial Data Log
- 256 KB
Serial Signals
- RS-232
- TxD, RxD, RTS, CTS, DCD, GND, DTR, DSR
- RS-422
- Tx+, Tx-, Rx+, Rx-, GND
- RS-485-2w
- Data+, Data-, GND
- RS-485-4w
- Tx+, Tx-, Rx+, Rx-, GND
LED Interface
- LED Indicators
- SYS, LAN1, LAN2, WLAN, Serial
Input/Output Interface
- Buttons
- Reset button
Physical Characteristics
- Housing
- Metal
- IP Rating
- IP30
- Dimensions
- 77.1 x 115.5 x 26 mm (3.04 x 4.55 x 1.02 in)
- Weight
- 470 g (1.03 lb)
- Installation
- DIN-rail mounting Wall mounting (with optional kit)
Power Parameters
- Input Voltage
- 9 to 30 VDC
- Power Connector
- 1 removable 3-contact terminal block(s)
- Power Consumption
- 11.7 W (max.)
- Reverse Polarity Protection
- Supported
Environmental Limits
- Operating Temperature
- 0 to 60°C (32 to 140°F)
- Storage Temperature (package included)
- -40 to 85°C (-40 to 185°F)
- Ambient Relative Humidity
- 5 to 95% (non-condensing)
Standards and Certifications
- EMC
- EN 61000-6-2/-6-4 EN 55032/35
- EMI
- CISPR 22, FCC Part 15B Class A
- EMS
- IEC 61000-4-2 ESD: Contact: 8 kV; Air: 15 kV IEC 61000-4-3 RS: 80 MHz to 1 GHz: 10 V/m IEC 61000-4-4 EFT: Power: 2 kV; Signal: 1 kV IEC 61000-4-5 Surge: Power: 2 kV; Signal: 1 kV IEC 61000-4-6 CS: 10 V IEC 61000-4-8 PFMF
- Radio
- EN 300 328 EN 301 489-1/17 EN 301 893 FCC ID SLE-1137C MIC NCC SRRC WPC KC RCM
- Road Vehicles
- E mark E1
- Safety
- EN 62368-1 UL 60950-1
- Cybersecurity
- EN 18031-1
- Vibration
- IEC 60068-2-6
MTBF
- Time
- 1,125,942 hrs
- Standards
- Telcordia Standard SR-332
Warranty
- Warranty Period
- 5 years
- Details
- See www.moxa.com/warranty
